Skip to content

CyclingCharger guides

11-Speed Ultegra Di2 Chargers: Confirm the Exact System

CyclingCharger editorial team · Updated 19 November 2026

Buying an older Ultegra Di2 bike? Verify its installed charging parts at handover, especially if the bike is advertised by groupset or speed count alone. Both RD-6870 and RD-R8050 can appear on used 11-speed bikes, and the installed battery and junction may differ from the original build.

Ask for evidence before collecting the bike

  1. Ask for a rear derailleur label and the battery model from a build sheet or recent service record. Don't ask the seller to remove a concealed battery for a photo.
  2. Ask for a clear photo of the charging point and its model, not just a photograph of the junction box. Check the legacy charts for the full combination.
  3. Ask the seller to show the supplied charger label and a normal charge start and finish on that bike. If they cannot show it, get the cost of the correctly identified missing equipment before comparing the offer.

Two second-hand examples

RD-R8050, documented BT-DN110 and EW-RS910
Verify the labels against C-473 and the SM-BCR2 charging route. Confirm the charger the seller actually supplies.
RD-6870, SM-BTR2 and an unidentified junction
Pause until the junction is identified. Shimano explicitly excludes SM-EW67-A-E with SM-BCR2 and SM-BTR2, so a photo of a junction alone isn't enough.

Keep the three component labels with your receipts for the next service. After confirming the build, compare it with the charger table or check the Di2 charger listing and ask about the supplied model.

Source: Shimano C-473, BT-DN110 and legacy system charts.