Skip to content

CyclingCharger guides

BT-DN320 and EC-DN100: Which Parts Come Off the Bike to Charge?

CyclingCharger editorial team · Updated 19 November 2026

A Shimano Di2 bike built around the removable BT-DN320 charges that battery in EC-DN100. This matters if you store the bike away from a power socket: the battery goes to the charger, while the bicycle can stay put.

Check the system before packing

  1. Confirm the model on the removed battery or in the build sheet. The C-842 system chart gives RD-RX827-SGS as an example of the BT-DN320 route.
  2. Check that the charger label says EC-DN100 and that you have its charging cord. Shimano's catalogue lists a cord with the charger; a second-hand sale may omit it. Verify the actual package and use the correct manual for power and indicators.
  3. Use the derailleur instructions for releasing and refitting the battery. If the holder will not latch normally or a contact is damaged, stop for service. Refitting and checking the battery before the ride are separate from verifying it charged.

Do not swap in the other 12-speed cable

For example, a group may have an RX825 bike with a BT-DN300 and an RX827-SGS bike with a BT-DN320. The RX825 route uses the EW-EC300 at the rear derailleur for the listed setup. The BT-DN320 needs the EC-DN100 charger, so sharing only the EW-EC300 cable will leave one rider without a charging option. Don't transfer a charging-time or LED sequence between the two.

Next: check the battery and charger labels against the compatibility table.

Sources: Shimano C-842 Di2 system; Shimano EC-DN100; Shimano specifications v029, battery and charger tables.