Skip to content

CyclingCharger guides

Where Is the Di2 Junction A Charging Port?

CyclingCharger editorial team · Updated 19 November 2026

On Shimano Di2 bikes that charge at Junction A, the charging socket can be on a box beneath the stem, at a bar end or in a frame fitting. There may be no loose box visible. Find the part and confirm the socket in its manual before plugging anything in.

Start at the cockpit

  1. Separate junction box: look around and under the stem for an SM-EW90-A or SM-EW90-B. The Shimano SM-EW90 diagram labels the charging port separately from the E-TUBE wiring ports, as well as the button and LEDs. Use the labels in the diagram to distinguish them.
  2. Flush mount: look at the bar ends and any labelled frame fitting for EW-RS910. Shimano describes this junction as a built-in bar-end or frame type. Use a torch and look for the controls and charge-port cover before assuming a blank bar-end plug is the junction. Don't prise it out.
  3. No match: check the component list or take a photo for your workshop. A box that turns out to be Junction B or a simple E-TUBE junction may have wiring ports without a charging socket.

Test the identification on a used bike

If a seller says “Ultegra 11-speed” and sends a photo of a flush bar end, ask for the EW-RS910 label or build sheet and the installed battery model. If the label is SM-EW67-A-E instead, Shimano expressly rules out the SM-BCR2/SM-BTR2 combination with that junction. Don't test fit a plug to resolve that uncertainty.

Next: check the battery and junction combination before selecting any cable.

Sources: Shimano EW-RS910; Shimano SM-EW90-A manual, names of parts (copy); Shimano C-473; EW-WU111 manual, example bar-end layout (copy).