Skip to content

CyclingCharger guides

Which Di2 Battery Is Your Cycle Computer Showing?

CyclingCharger editorial team · Updated 20 November 2026

A battery symbol on a cycle computer may not be the Di2 main battery. Check the field name and the paired sensor. A computer's own charge, a power meter battery, a Di2 main battery and wireless-lever batteries are different readings.

Start with the data field

The RD-R8150 manual says the derailleur can transmit gear-position information, Di2 battery level, dual-control-lever battery level and adjustment-mode information to receivers supporting the relevant ANT or Bluetooth LE connection. It also says the information actually displayed depends on the cycle computer or receiver.

What a displayed reading can and cannot establish
Field you identify Useful check Do not conclude
Di2 main-battery level Compare with the model's local battery check when the bike is awake and connected. That the lever coin cells or power meter have also been charged.
Lever battery level Identify the specific lever information supported by your computer. That a main-battery charger will replenish that cell.
Computer or another sensor battery Read that device's own instructions. That this is a direct measurement of the Di2 battery.

Connect without guessing a menu

For the RD-R8150 cycle-computer connection, Shimano describes putting the computer in its connection mode, performing a gear-shifting operation and following the computer's screen to select the device. The exact screens and available fields belong to the computer's manual. A normal stationary check should use a secure bicycle setup, with the charging cable disconnected.

If the computer still shows an old value, verify that it is connected to the intended bicycle and that you are viewing a live field rather than a saved ride. A stale or absent field alone does not identify a failed battery or charger. Record the local indication, field name and sensor identity before replacing parts.

Make the charging decision separately

Use the RD-R8150 local check for that model. If the main battery is low, use its correct charge route. If only a lever is low, use the lever-battery instructions. A display of 50% is not a promise of a fixed remaining distance.

Sources and scope

Checked 20 November 2026. Model-specific instructions take priority over a general guide. This article is not a report of independent compatibility or battery testing.