CyclingCharger guides
Di2 Loses Charge While Parked: What to Record Before Replacing Parts
CyclingCharger editorial team · Updated 19 November 2026
A flat Di2 system the morning after charging could reflect an incomplete charge or a loss while parked. Establish which one you can reproduce before replacing a battery or charger.
Make one useful record
- Verify the model-specific completion signal and unplug. Record the time, battery indication and the cable and source used. “The light was off when I arrived” is weaker evidence than seeing normal charging start and reach completion.
- Leave the bike unused in normal indoor conditions, then check with the same indicator under similar conditions. Note elapsed time, temperature, any app session, and whether shifting responds. Do not intentionally run the battery to zero.
- For the EW-WU111 wireless unit, disconnect the Bluetooth LE session when finished with E-TUBE PROJECT on the phone. Shimano warns that leaving it connected can increase consumption. Record whether the session was active; that clue does not prove it caused a flat battery.
How to read the result
On RD-R8150, going from steady green to flashing green crosses a band boundary; the indicator alone cannot tell you the percentage lost. Repeating a large change after a confirmed charge with the bike unused, or losing shifting again shortly after charging, gives a workshop more useful evidence. Stop and seek assistance if there is moisture, damage or abnormal heat.
Bring the two readings and exact component models. Use the RD-R8150 indicator table for that model.
Sources: Shimano RD-R8150 battery level check (copy); Shimano EW-WU111 UM-2710B, Bluetooth LE notice (copy).