CyclingCharger guides
RD-R8150 Flashes Red During Charging: Check the Source and Connection State
CyclingCharger editorial team · Updated 21 November 2026
First confirm that the RD-R8150 is flashing red while charging, not while pairing. The manual gives different causes and actions for those two states. A red colour alone cannot identify the failed part.
Record the state before changing equipment
| When it flashes | Manual branch |
|---|---|
| During charging | The current may be insufficient; check the USB source and connection. |
| During pairing | Check whether the switch supports wireless communication; retry pairing through the applicable instructions or seek service. |
Note whether the dedicated cable is connected, what the phone/app is doing and which button action preceded the flash. Do not replace a charger because a wireless-pairing attempt produced a red signal.
Use the charging-error checks for this model
For flashing red while charging, the RD-R8150 troubleshooting table says to use an AC adapter with current capacity higher than 1.0 A. If a USB hub is being used, it says to reconnect the charging cable directly to the AC adapter. The general safety page separately specifies 5.0 V DC and at least 1.0 A DC for the USB AC source. Preserve that distinction between the minimum specification and this particular fault remedy.
Read the output label of the actual port and use the correct dedicated cable. Overall adapter wattage, the UK mains input voltage or a similar plug does not establish the supported source arrangement. This guide does not verify a particular hub, adapter chain or power bank.
When the branch does not resolve it
- Stop for visible damage, wet connections, abnormal heat or other unsafe conditions.
- Keep the source label, cable model and exact light behaviour in the service record.
- Follow the component instructions; do not repeatedly reconnect or bridge terminals to force charging.
- If the permitted checks do not resolve the issue, contact the place of purchase or a qualified workshop.
For a normal battery-level check, use the separate short-press LED interpretation. If the app interrupted a charge, see the E-TUBE state check. Neither branch proves that the shop's current charger offer is a suitable replacement.
Sources and scope
- RD-R8150 troubleshooting: charging and pairing red flashes, p. 3 (copy)
- RD-R8150 source safety requirements, p. 1 (copy)
Checked 21 November 2026. Use the exact component instructions and current supported system. This guide does not claim independent compatibility testing of the item sold by the shop.